How do use the Conversion System in corners?Updated 10 months ago

For a corner between 90 degrees and 180 degrees:
We do not carry any special components or hardware for corners, as the standard components of the Existing Fence Conversion System can be used in corners. You will simply need to install the mounting plate in the corner, then position the spring-loaded arm at an angle to split the corner into two equal halves.

For corners greater than 180 degrees:
We do not carry any special components or hardware for corners, as the standard components of the Existing Fence Conversion System can be used in corners. However, corners that are greater than 180 degrees (inverted) do require additional spring-loaded arms to ensure the Purrfect Fence functions as expected in these areas. For corners that are between 180 and 270 degrees, you will need two arms. For corners between 270 and 360 degrees (uncommon) you will need three arms.

The mounting plate allows for up to three arms to be inserted at once, so you should not require more than one mounting plate for most configurations.

For corners less than 90 degrees:
If your fence has a corner that is less than 90 degrees, then you will need to “skip” that corner. This can be done by running the Purrfect Fence in front of the corner to create two “new” corners. Then the mesh is worked back into the existing fence corner so that no gaps exist.